Posted by Wardner on October 23, 2009 at 10:11:37 from (4.154.247.228):
I am adding a few more PTO's to my 400. Total cost should be reasonable at around $200. I found a cheap source of bearings at VXB Bearings.
I will cut off the integral hollow shafts on the former IPTO driving shafts from SMTA, and 400-450. I will make new solid shafts that will be keyed to the gears. I would like to retain the original hollow shaft but the bearings are too large.
I will need to make four bearing retainers/seal holders. The 1-1/8th shafts will extend from both sides of the aluminum 4X4 block. The front end will accept a six or seven inch pulley. The rear end will take a three inch cogged belt bulley or U-Joint.
The RPM's will be at engine speed.
My thanks to Nebraska Kirk for sending me his old IPTO driving gear that he is replacing with a new gear having fresh splines.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.