Posted by Wardner on October 23, 2009 at 15:32:59 from (4.154.247.228):
In Reply to: Re: My next project posted by KIP in MX on October 23, 2009 at 10:48:54:
Too early to know what the PTO shafts will drive. It's kinda like "if you build it, they will come". That means the ideas or opportunities will surface at some point.
I do have a 150 CFM Sullair screw air compressor but that hardware takes up alot of space with the air receiver/oil separator. It also needs an oil cooler.
I am open to suggestions. What about a caliope? A pumpkin catapault or cannon? A portable bell tower? A welder might be useful.
When you think of all the planters and harvesters that IH engineered and built, you have to be impressed with the utility and imagineering that went into these machines. Maybe I can do myself proud with my own attachments. I must say that I do get bored going to a tractor show and seeing row after row of identical tractors. I go to see if any vendors have unusual stuff.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.