Farmall & IHC Tractors Discussion Board |
Timing a SA distributer Any suggestions welcome!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by scott#2 on December 03, 2005 at 18:16:11 from (141.156.238.167):
I have searched hi and lo for the mark on the flywheel that you line up with the tab on the cover. I swear it is not there. Cleaned, rubbed polished searched, searched, searched. It just aint happenin. Does anyone know hom many degrees btdc or atdc or is it at dead tdc that # 1 fires at? In other words, does anyone know exactly where in the stroke, #1 piston is, when that elusive mark on the flywheel is lined up? I need to at least static time this thing before I try to fire it up. After that, I suppose I can mark the flywheel or pully and then check the advance, if it uses advance? Thanks for any help, scott#2
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|