|
Farmall & IHC Tractors Discussion Board |
More MD questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brad Whitty on July 10, 2001 at 10:22:11 from (206.190.72.128):
After reading everyone's posts regarding the M and MD models, it appears that I do not have the right side "pulley" that works off of the Lift all. I was looking at the tractor and cannot even figure out where it would go. Also, my tractor has two hydraulic levers that are mounted on a pedestal on the right axle, just about shoulder level. This must be some home made set up, correct? It looks like one hose would go to the Lift all in the tractor, route through the levers, and return back to the Lift all? There are two hydraulic couplings that come off of the levers that I assume implements would attach too? Now the BIG question. Can I remove the Liftall pump from the MD's belly with out having to separate the tractor in half? I have order manuals but it will be awhile before they arrive. Thanks for your help and this forum. Brad Whitty
'41 MD
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
