|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: More MD questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brad Whitty on July 11, 2001 at 13:38:39 from (206.190.72.128):
In Reply to: Re: Re: Re: More MD questions posted by Haas on July 11, 2001 at 04:50:51:
Thanks for the reply. Yes, there is a flat plate bolted just in front of the battery, on top of the transmission. There is no extra holes on the plate. That "extra" 1/2" pipe fitting comes out on the right side of the pump, at the bottom rear of the pump (5 o'clock postion)I see the 4 3/8" bolts holding the pump up in the belly of the MD. I have one more question. I talked to "Quality Farm and Country" the other day in Iowa about their catalog listing for a wide front end that fits the M. I asked if it would fit the MD and he said yes. However, the front end does not come with the hub and rims. My MD has one wheel on the front, not two, like yours. Is it easy to find hubs and rims for this wide front if I ordered it? I live in the mountains on the Central Coast of California so the wide front is important. BTW, I was in the mountains of NC(Blowing Rock,NC) this time last year. I was born and raised in NC(New Bern). Are you located near the NC/Tenn state line? Thanks again for the help, Brad Whitty
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
