Posted by Goose on October 19, 2009 at 19:23:18 from (67.63.68.13):
Several days ago, we had a rather spirited thread about combines on public roads. I was abruptly taken to task for opining that some combine operators could be more alert and courteous when encountering motor vehicles. At least one poster voiced the opinion that all vehicle drivers are stupid morons.
Fast forward to this morning. U.S. Highway 77 is a four lane highway between Lincoln and Wahoo, Nebraska with a 65 mph speed limit. It's also the main north/south route through that part of the state. I was coming south out of Wahoo with my cruise set on 67 when I topped a rise in the road and came up behind about a dozen assorted vehicles behind a combine blocking both southbound lanes and going about 15 mph. He was centered exactly on the centerline and the header was wide enough to cover both lanes completely. From my vantage point at the rear of the pack I could see mirrors projecting out about two feet on both sides of the cab, so it's reasonable to assume the combine operator could see the traffic behind him.
At this place in the road, there is a hard surfaced shoulder almost as wide as a traffic lane, and the header on the combine was lifted high enough to go over the reflector posts, so there's absolutely no reason the combine operator couldn't have drifted onto the shoulder without breaking his speed and cleared one lane at least long enough for the traffic to pass.
This went on for another couple of miles with more traffic piling up behind me. Finally the combine turned off onto a side road. If the combine operator was capable of coherent thought, he was probably thinking how nice it was of the State of Nebraska to build this nice wide 4 lane highway for him to run his combine on.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
