Tractor Talk Discussion Board |
Nearly lost my trailer.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by dej(jed) on March 30, 2007 at 05:36:14 from (67.140.50.4):
I pull a 7000 lb Appalachian trailer with my GMC. I have been doing it for years. I took it to the shop for new rear brakes and when I picked it the guy cautioned me about my hitch. It is a class 4 hitch that mounts to the frame with 3 -1/2 inch bolts on each frame rail. The receiver is an extension from that. Well the hitch was bent to the right slightly. Needing to haul an Oliver 55 I figured we could haul it that evening and get a new hitch the next day. We loaded the tractor and headed home. About 5 miles from home on a major 4 lane, I began hearing this grinding noise. After a bit I pulled off the road and as soon as I hit the berm all hell broke loose. The hitch bent and the trailer tongue and all was down on the road. The moral of this story is , Check Your hitch once in awhile, they make a lot of scrap these days.
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|