Tractor Talk Discussion Board |
Re: will a house 5ft brush hog tear up my ford 8n
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by DickTN on August 02, 2006 at 15:56:24 from (68.84.93.85):
In Reply to: Re: will a house 5ft brush hog tear up my ford 8n posted by Jody Nalty on August 02, 2006 at 05:17:02:
Jody, the bearing and seal can be changed on the PTO shaft. However, it will take at least a 10 ton press to get the bearing off. Your call, of course, but unless funding is a problem, I'd elect for the 1-3/8 shaft which will come with the new bearing and seal already installed. Of course, this will require a different ORC if you have the original 1-1/8" shaft installed now. Procedure for changing the shaft is simple. Nose the tractor down into a ditch (avoids losing hyraulic fluid), remove the four bolts holding the PTO assembly in, take the old shaft out and stick the new one in. Job done. HTH
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|