Tractor Talk Discussion Board |
Re: will a house 5ft brush hog tear up my ford 8n
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jody Nalty on August 02, 2006 at 05:17:02 from (68.35.43.16):
In Reply to: Re: will a house 5ft brush hog tear up my ford 8n posted by DickTN on August 02, 2006 at 04:12:17:
Thanks for the info it has the coupler already in place and there is some chains there i will have to make adjustments I am also trying to locate the implement bars that go from rear end to the implement I did notice that the is bearing slop on the pto I am guessing they can be replaced as I am new to this and learning as I go also have a slow leak down on 3point and my drive line hits if i raise to high am not sure what to do about this any sugesstions will be of great help thanks for the replys
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|