Tractor Talk Discussion Board |
Towing with an f150 supercrew 2003 model?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hurst on May 24, 2005 at 14:19:15 from (66.129.5.5):
How much can this model truck tow safely with a standard bumper hitch with a bumper pull trailer? I was thinking about towing an allis chlamers 7000 with it, but wasn't sure if the truck's frame could handle pulling that weight, even if the weight is not on the tounge too much. This truck has been rear-ended and had to have to frame heated and straightened about 2 or 3 degrees in the bend. Will towing something this heavy possible mess up the frame again? Is there anywhere that is in central Ky to rent trucks with gooseneck balls in the beds, I can probably borrow a gooseneck if I can find a truck to pull it with. By the way, the f150 doesn't have a ball in the bed, just a bumper hitch with the towing package. Thanks Hurst
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|