Posted by Livewire84 on September 24, 2018 at 22:35:39 from (216.81.96.196):
I recently bought a tractor.
Thanks to Majorman, he helped me identify it as a 1963 fordson new performance super major sold as a ford 5000.
The issue i am having is whenever i engage the pto with the handle in front of the clutch, the output shaft starts turning ( which is ok ) but the 3 point hitch lift arms, go all the way to the top. I cannot make them go down, or stay in a neutral position between up and down. I do not have anything attached to the 3 point hitch right now.
The only way the arms go down is by disengaging the pto and after a few minutes, they will go down, very slowly.
Engage the pto and they go straight back to the top.
It did this before i changed the fluids in the transmission and rear end. I used 15-40 in the motor, transmission and rear end and all the levels are where they should be.
There is a control handle to lift and lower the 3 point hitch, and a handle to the right, under my seat.
Should this handle be up or down ?
I dont have anyrhing plumbed off of the hydraulic block at all. .
Those 2 control handles are all that are there. I do not see any kind of flow control, or a push pull type knob or anything.
Which position should the handle be in ?
Up or down for 3 point hitch use only ?
And why will my lift arms go up, but not down when the pto is engaged ?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
