I connected a set of harrows (which are pretty heavy )to the 3 point hitch and the tractor would only lift them with the engine reved about 1/2 way, but It finally picked them up slowly.
My father in law happened to turn the draft/position control handle, several times while the weight of the harrows were hanging , and the disc finally fell when the position lever was all the way down. Before that, the only way to let them down was to disengage the pto, and let the weight pull the arms down. So a valve must have been stuck, but somewhat started working again.
Now the issue is that the tractor will only lift them with the engine reved up. Without the engine being reved, the arms will get tight, but not enough force to lift them.
I noticed that if i push down on the draft/position control handle while the engine is idling, the arms try to raise, no matter the position of the lift/lower position handle.
Also when i pull the lift/lower position handle it seems to be connected to the draft/position control handle.
If i just easily switch the draft/position control handle down toward position control, and do not hold pressure downward on the lever, the arms will do whatever the position lever is telling them to do.
As i pull up, to lift a attachment, the draft/position handle rises up about 1-2 inches, along with the lift/lower position handle.
I dont know if that is somewhat normal with super major, or if i have possibly found the problematic area, or do i have a huge mess on my hands.. lol
I am at a loss again, on this issue, and i hope i have explained it well enough.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.