Ok, if you can understand this terrible artwork of mine, the blue circle is the area you are working on. Nevermind the errant blue mark I made. Now the red arrow is where you would weld the wear strip on. There is a shim in there, but that'll burn in when you weld it. You didn't hurt anything by running it that short of time. Most likely it would be fine without anything holding that wear strip, but better safe than sorry. It just protects the track frame itself from direct wear from the idler brackets. I've seen many that were so worn out the welds wore off and there was no remaining wear strip left, and they had been that way for a long time (lot of wear on the track frame). If you get that area cleaned up, you'll see the wear strips in there on the bottom side of the top rail of the track frame, both sides of each frame. The wear strips are roughly an inch wide, about 10 inches long, and around 3/8 of an inch thick. If you weld it, just weld it horizontally across the 1 inch width of the wear strip. That will allow you to cut it off easier when you can afford to fix it correctly. Now in the course of running it, if you happen to see the track losing tension, that will be because the adjuster shaft is maxed out and grease is leaking around the seals. Thats where some guys will make the spacers to go in between the adjuster yoke and the idler bracket, to get the idler farther out without running out of stroke on the adjuster cylinder. Like I said, once it starts getting out past the end of the track frame very far, that is when you'll really need to start doing something, fix the tracks or take a link out to buy a little more time. Hope this makes sense.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
