Posted by hayfarmer on September 06, 2016 at 12:48:37 from (71.84.179.83):
In Reply to: Ford-600 posted by moday on September 06, 2016 at 09:20:51:
will add one more way. On JD 430 my backblade on the tractor or rotary mower hanging on 3 pt will pretty well balance out the back half, in fact I have had to lower implement to keep it from pointing up. I still use blocks under in case. I roll front half away. Block front axles so that it will not tip side to side. I put long blocking under floor jack, and block of wood to spread force, and jack under wood blokd on bottom of oil pan. Put jack on blocking so it will roll ,a wider board helps. with front jacked up level with back I pull front haf ahead with come a long hooked to tractor, pick up or whatever. Jack should roll with front end. I agree with using line up bolts to go back together, just make sure they are not too long so you can remove them after halves are together, I know from experience. My favorite way to split tractor is with hoist or front end loader, unfortunately when you are splitting your loader tractor that doesn't work.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.