Posted by skipstein on April 23, 2016 at 08:40:39 from (99.11.18.142):
Hello All; On my 8n, I have flushed out the radiator, replaced the hoses and installed a new thermstat in the upper hose. Prior to doing all mentioned activities, my 8n ran HOT. I should mention that there was NO termostat in the upper hose. Hopefully after the cleaning and flushing the radiator and eengine, having a thermostat inline, it will run cooler. My question is whether I should source and install a FAN SHROUD for the 8n? I have seen many an 8n without a fan shroud, but am willing to get one and install it brfore putting the hood back on the tractor, if it will help keep it at normal operating temp. One other question, if I may, has anyone installed a temperature guage on an 8n? I wonder where to moount the gauge and install the sensor? One final question, what is normal operating temp of the 8n? The new thermostat is a 160 degree unit, so is it that range? Any thoughts on use of a fan shroud and mounting a temperature gauge and sensor on an 8n are greatly appreciated. 'Thanks, Skip
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.