I would try putting in a thermostat first, 160 would be sufficient. I don't know if it originally had a shroud, but if it did, it needs to be there.
The temp sensor needs to be in the head, below the thermostat. Down in the block is too low, too far from the combustion area, will give a false cool reading.
If it has a history of running hot, there may be a circulation problem (rust) or a leaking head gasket.
A circulation problem, as in clogged radiator or coolant passages in the head, will typically show up as overheating under load. If the engine is hot, yet the air coming through the radiator is cool, there is a blockage. Also, feel the front of the radiator. If there are cold spots, it is clogged internally. And double check for external blockage, they can pack with sand and grass.
Overheating at idle, or blowing coolant out even when the engine is cool, emulsified coolant/oil accumulating in the crank case breather tube or under the oil cap are all signs of a leaking head gasket. Flat head engines are prone to head gasket problems. Typical causes are from being overheated, warped head, or improper installation.
If you do end up pulling the head, it will need to be surfaced and checked for cracks. The coolant passages in the head and block need to be cleaned. The block surface needs to be thoroughly cleaned with Scotchbrite. This is easier with the studs removed. If there is any doubt about the studs and nuts, replace them.
These are just generic answers, to get more model specific results, try posting on the "N" board below. Also a shop manual will be a very valuable investment!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
