Hot Spark!!!!!! The energy that is dispersed in the spark across the plug gap is stored in the inductor (coil) as 1/2 L [inductance of the primary in this case (7 mh for a number) x actual current flowing at the instant the points open squared].
So for a 7 mh coil and 4 amps you have 1/2 (7 exp-3) x 4 exp 2 for 56 millijoules....(mj defined as a volt x amp x second and is a measure of energy. Get it going via pulses per unit of time and you are consuming energy at some rate which is work, measured in watts or horse power, 746 w/hp)
But for the same coil and 5 amps you have 88 mj, some 60% more energy.
The voltage across the coil both primary and secondary per the turns ratio will rise to infinity theoretically when the current attempts to stop due to the points opening, in an attempt to keep it moving.....nature of the beast. The actual breakdown value of the plug depends on the pressure on the plug from it's environment and the gap. The "heat" of the spark is the energy in the arc (volt-amp-period) across the gap and that comes from the coil. So low current, exponential loss of energy. Question is, how much does it take to fire the plug in a given engine at a given time that contains enough energy to light off the available fuel air mixture present at the gap?
On the resistor getting hot, that's the reason it's built the way it is. It's in a high wattage package with provisions for mounting to a heat sink...a piece of sheet metal on the tractor somewhere.....sorry heat sink but better than nothing.
Talking about coils getting hot from running, what always got me was the mounting of the coil right on the side of the engine block. Convenient, yes, but there are better places that are cooler.....course the fan blows across it and I guess that makes it ok.
Mr. JMOR sir, got time for those pictures of the points with and without the capacitor (condenser)?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.