In the time difference of 2.5 down to 1, that says something right there about the voltage in the spike. With the joule being VAT, if T shrinks by a factor of 2.5 then V or A....gotta be V cause the coil wouldn't let A change immediately, must have gone up 2.5x. What's the bandwidth of the vertical input of your scope? Possible that the spike jumped up there and the scope didn't catch it; maybe a little tweak of the V sink would have caught it.
I spent a lot of time in industry with pulse modulated circuits, high voltage, arcing, and all that and know that when you attempt to interrupt the current in an inductor, you had better do one of two things or both: limit the actual voltage with something like a zener diode or VDResistor, or limit the rate of rise to something less than what would produce the arc. The C is there to do that. Surprised you went through the range you did with no results. Course since you were increasing the C from what I learned was THE value, you already had the arc under control. Always heard that .01 was the value of caps used across breaker points. Don't know as I never measured one nor saw it stamped on the case.
I've been retired 10 years and forget and forgot a lot. I enjoy these brain tweaks as they keep what little brain I have left, active and I hear that helps to ward off Alzheimer's, speaking of which my lil'sis was here for a couple of days with her hubby who is in the preliminary stages. Really sad, sad, sad. He's just like a little kid. Drives her crazy but she has a good spirit and loves him. The visit did her good as she got to see her son home from overseas and his family plus a couple of weeks of breaking with the routine.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
