Posted by dave2 on November 22, 2011 at 05:34:55 from (79.240.162.81):
one of my projects in the next couple weeks is heat tape on stall lines. Water source is in a place that we keep between 35-40 degrees in winter and my drinkers are set up so they can be run in a series and I need a line ran about 70 ft (ditch) to a faucet for the back yard stalls. Just got to thinking that it might save energy and the ditch that I am really not ready for (need to finish/do a couple other projects) if I'd start with a small water heater at the source, run thru my drinkers in series, then to the back yard faucet, with a return line back to the tank. Then a circulation pump on a thermostat/timer and heating the water a little for really cold days/nights. Thinking a little circulation pump running 15 minutes +/- an hour would use less power. If all that would work, It'd give the added benefit of a hot water source for a pressure washer and utility sink when needed (by turning on the HWH)
Am I missing anything? Cost is not an issue because I already have everything on hand for both ways.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.