Posted by colby64 on April 28, 2012 at 17:37:45 from (98.215.42.86):
MORE PROGRESS....
We got the other frame rail back from sand blasting, primed & remounted, removed the side you can see in the photos below.
Rear rims are done, sand blasted and powder coated, taking the other frame rail over for blasting and priming. Also taking the rim hardware (bolts & nuts) over to get blasted and powder coated to match rims. Very carefully they will be remounted with new tubes and will go back on after tractor is RED.
Head is back from machine shop good to go!
Got the word more loose parts are red... fuel tank, front weights & rear weights, and few other parts.
Next week in the stop we'll get head back on, remove oil pan to install new gasket. Then we just have few loose ends to get done, another steam cleaning.... THEN off to sand plaster and primed, and RED PAINT!
CANT WAIT!!!
You would not believe the pile of parts waiting to be installed... crazy.
Honestly still think we can make RPRU in July...
Lots of RED parts downstairs just waiting :) My wife will be glad when they are gone that's for sure.
This post was edited by colby64 at 17:53:12 04/28/12 3 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
