Posted by Chshaffer on March 12, 2012 at 18:49:51 from (70.105.179.83):
Received an I & T Manual today in order to determine engine specifications on a 656 diesel tractor that I am working on. One of the specifications I was most wanting to determine is the cylinder sleeve protrusion on my engine. The manual gives a .001 to .004 inch dimension for engine serials less than 71788 and a maximum allowance of .002" variance between cylinders. It does not however give dimensions for engines with serial numbers higher than 71788 but only that the height gauge tool bottoms out on the cylinder block. What are the dimensions for the cylinder protrusion above the block if one does not have that tool. This tractor was bought not running from a tractor jockey and I discovered a blown head gasket between number 2 and 3 cylinders. Had the cylinder head checked by a professional mechanic that indicated the head was not warped. From what I observed in taking this engine apart this far is that someone had been inside this engine before. Thanks in advance for any specs you can share.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
