Posted by Tom Fleming on October 23, 2011 at 03:43:43 from (67.20.249.95):
In Reply to: C lube fill/drains posted by soundguy on October 22, 2011 at 22:31:59:
I have pulled a couple of the front pulley's off, and there are some excellent posts in the archive on this subject.
I use the 8" bearing splitter, with a snap-on heavy duty puller. Works fine using a 1/2" impact wrench. I do heat the pulley shoulder up a bit with the acetylene speed wrench......just don't over do it. Also, you need to pop it "loose" before using the impact wrench. Torque down the puller, and rap the puller center bolt with a couple of moderate blows. Torque some more, then rap again. usually after the 2nd or 3rd iterations of this, the pulley will pop loose.
When it first pops "loose" it will make a sound that causes you to think you've been shot and you will have skid marks in your knickers. These old girls do NOT come off with common 3 jaw gear puller's. Don't even attempt it with one of those. Use a 2 jaw puller, minimally rated 7 tons or more. My puller is rated at 15 tons.
IMHO of course.
This post was edited by Tom Fleming at 17:17:00 10/25/11.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.