Posted by Lmack on September 27, 2011 at 21:04:03 from (72.145.203.180):
In Reply to: super a belt pto seal posted by werowance on September 26, 2011 at 18:44:35:
You also have to understand that the standards for oil and grease retention was not the same in the 1950's. The post are correct that the ring is part of the assembly. With the best of seals the end of the shaft will leak a little oil. There are shim spacers on the end of the shaft and from the factory nothing was done to prevent oil seepage through the shims. I have used liquid gasket between the shims and it has worked fine. There is no oil seal between the ring and the shaft so a little oil is going to seep through the end of the belt pulley shaft.
If you remove the pulley you must install a cover to keep the ring in place or it will come off. I have made slip covers from 1 1/4" fence rail cut to 2 1/8" long. Use a pipe cutter or it will not be square.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.