Posted by werowance on September 26, 2011 at 18:44:35 from (75.246.246.1):
hi all, have a super a with a woods mower that runs from the belt pto. been leaking for a while so i made a special tool on the lathe to finaly pull the woods pulley off the shaft to get to the seal. havnt take the seal out yet but there appears to be either a repair sleve that has come lose or i have read in the forrum that it might be the factory spacer. at any rate it is a little thin sleve that is moving and slid right out from the seal, looked like it might be made of bearing material like crank shaft bearings would be made of, ie lead coated copper or something. so now im afraid that it might not be a normal seal repair sleve.
so my questions are: is this the factory spacer i read about? if so can i just silicone it to the shaft to keep it sealed and from moving around? or is do you all think its a repair sleve? also, do i need to take the pot metal cover off to replace the seal or can i just pull it and drive a new one in place like an axle grease seal?
and on a side note, anyone who has tried to remove the woods mower pulley without luck, the tool i made works great came right off and only needs one wrench, 4 days on my lathe, then a heat treat, not bragging, but really my first tool ive made on my new metal lathe and it worked perfect. so its a "loan a tool" now if anyone needs.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.