Posted by CNKS on February 16, 2011 at 17:56:09 from (216.144.104.128):
In classic view, the post dropped to page 2, it is in the link. Briefly, the timing marks do not line up at TDC. My long explanation in the link is incorrect, as I tried starting the tractor with the timing marks aligned, and again with the piston at TDC. In both cases the engine begins turning and stops, meaning the spark is occuring at the wrong time. This tractor ran before, did not have oil pressure which I corrected by removing the governor and plugging the hole at the end of the oil galley. Obviously I reinstalled the governor wrong. But, I did not find a double punch mark on the cam gear as the service manual said, but single marks on two adjacent teeth, I put the double mark on the governor gear between the two singles on the cam gear, thinking that was the "double" referred to. Wrong. So I'll see what I find tomorrow and report back if I ever get it fixed.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.