Posted by pete 23 on March 11, 2010 at 10:43:40 from (173.87.0.197):
I am curious if anyone else has found the timing marks on a D-361 engine flywheel to be off by approx 10 degrees. I found this out when measuring piston protrusion above the deck. I had made a seperate pointer on front pulley before splitting tractor because it is hard to be real sure of the flywheel pointer as it is in the cluch housing after you split. When I turned engine to tdc mark piston was no all the way up, so I made my own tdc mark by the normal method of dialing up to stop, down .001 and back other way to down again .001 and then split the difference for true tdc. This of course means the timing at the pump is way off, almost 10 degrees early. Hard starting is the problem I am checking on, but owner claims it used to start fine. Hard to believe. History of engine it knocked rod out many years ago, reground crank, large end of rods have been machined once for sure and I think twice that is why I was checking piston protrusion. That is another story, but I was just curious if anyone has ever seen timing marks that far off and a possible explanation except flywheel marked wrong or dowels in crank wrong.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.