Posted by The tractor vet on March 11, 2010 at 15:19:33 from (75.19.124.251):
In Reply to: D-361 timing marks posted by pete 23 on March 11, 2010 at 10:43:40:
Ya know Pete i have never paid that much attention to that over the years as when i do a 361 i always pull them and do a total rebuild and use the .010 sleves to make sure that the core shift is out of the block as i have them line bored and then set up off the centerline for the boring and a light dusting of the deck and a light cut on the contour bores and have always set TDC off the timing marks and i guess i have always assumed that they were correct and it is set at what i have always believe to be TDC . then put the ft. cover on then the pump after i have it setting in the chassie . I know way back when Ford was still using the FE block 360 in the pickups that the ft. harmonic Balancers on the 70-71's were way off and trying to get one to run at 5 degrees BTDC was a real treat as it was off by 15 and if you set them at 20 they ran great . So now i will have to check real close on the next one and see .Thanks for the heads up .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.