Posted by Mark on November 03, 2009 at 15:46:46 from (71.30.209.232):
Friends,
Many thanks for all the information you shared in my original post which is now a couple pages deep.
Today, with the help of friend, we went over the electrical system with a fine tooth comb.
There is fire through the coil (bought a new non resistor 12 volt type today). We took the coil lead and arced to the frame as we cranked the engine...a nice hot spark appeared. That"s good.
So, we know the points are working and voltage is being sent to the distributor cap.
The distributor cap and rotor button and plug wires are all new.....as is everything else, just so everybody knows...all the components have been replaced.
But.....there is no spark being distributed to the plugs....none, nada, nope, nothing! OK, I take the old distributor cap and button and try them.....still nothing. I use the new cap with the old button, nothing. I then used the new button with the old cap.....nothing.
Remember, the coil wire tosses a dandy spark when arced to the frame of the tractor....that same wire gets inserted into the distributor cap and from there....the spark ends.
Why isn"t the juice going through the cap?
The system is making electric through the coil and points....as evidenced by the coil wire arcing to the tractor frame....but once plugged into the cap(s), it ends!
My pal attached his Fluke meter to every electrode on both caps and it beeped continuity....so the caps are not bad...or so it seems. The rotor buttons are perfect....one is brand new.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
