I may be wrong but I got the impression from your last post that you may think the throw-out bearing is the same as the pilot bearing.
The pilot bearing will be a ball bearing pressed into the end of the crankshaft but more likely into the flywheel. They can seize up and eventually grab the splined clutch shaft through a galling action. I had a Cub do that to me many years ago. The main difference with the Cub is that the pilot bearing was a bronze bushing. Your bearing should have made some noise when disengaging the clutch before it seized on the shaft. This is not a diagnosis of what is actually wrong with your 504.
A throwout bearing may have some wobble. The bearing will still be good. It is just the bearing carrier/yoke that is allowed to find its center when pressed against the pressure plate fingers. In other words, it floats a little.
I don't fully understand TA's as well even though I have replaced one and, at the same time, changed the output bearing, flange, shaft to the larger size. I just set them according to the manual.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.