Posted by Janicholson on November 23, 2008 at 07:26:46 from (66.173.50.91):
In Reply to: 300u starter switches posted by Rick Bachman on November 22, 2008 at 11:04:27:
I have a clear image in my head of what you have. The toggle switch has its input wire hot at all times. the two wires leaving are going to be powered from that switch when it is on, and no power will flow when off. The switch is wired correctly. The wire going to the push button momentary contact is correct to supply that switch with power. that switch then is connected to the starter S terminal on the relay on the starter. Again correct. The other wire on the toggle goes to the ignition coil to give it running voltage. It is correct. The toggle switch is bad. Disconnect the coil where the lead comes into it (small probably minus marked terminal) Use a jumper wire to jump across the toggle switch terminals nothing should happen, if it does there are possible shorts in a wire going to the coil. Now test for volts at the disconnected coil wire (it should be battery volts). Push the starter button (it should spin and crank (neutral is a good idea)). Now reconnect the coil and start it! Needs a new Toggle switch, get a water resistant one that handles 20 or so amps. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
