Your info above does not exactly tell me which terminal you got 12v on, or when. The wire supplying the toggle switch should come from the load side of the amp meter. (not the side hooked to the battery lead on the starter relay) This will give the toggle sw power all the time on one of its terminals. The other side of the toggle sw should have the wire going to the coil (or the ballast resistor on the coil if it needs one), and one going to the push button starting sw. If the output side of the toggle switch is not hot when the switch is on, it may be a bad sw. If the input side of the switch goes dead with it on, you may have a bad connection.wire going to the amp gauge load side. or the wire going to the starter battery cable connector. The coil should be either a 12v no external resistor required, or a 12v with resistor required (with a resistor) or a 6v coil with the resistor. Unless it is cranking, you will not be testing the coil. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.