Hate to say this, but I believe rod knock exhibits this trait. When unplugging the spark plug, there is no explosion in the cylinder, so there is no tremendous force being placed on the piston and the rod, so the noise goes away or at least gets quieter. It is very difficult for one cylinder to get out of time from the rest, because each cylinder's timing is determined by the wires position in the distributor cap. Check the firing order, check the cap for carbon tracks or cracks, check the plug wire. A failing rod bearing will not greatly affect compression, so it is a possibility. If it were debris in the cylinder, it would have continued making noise when the spark plug was disconnected. I hope I am wrong, and that someone else can give you a better diagnosis!!
On a side note, many people have the opinion that if it won't start by itself, there is something wrong to begin with, so don't bother using starter fluid, as it will just cause more problems. Its use plays havoc with rod bearings and engine internals if used in excessive quantities. I wouldn't use it at ALL in a gas motor, unless you are planning to rebuild it in the near future, or don't depend on it for anything.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.