Farmall & IHC Tractors Discussion Board |
Re: Farmall 300 Hydraulics Again
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Owen Aaland on July 30, 2007 at 21:19:20 from (65.165.246.212):
In Reply to: Farmall 300 Hydraulics Again posted by Matt Weltz on July 30, 2007 at 19:43:38:
The hydraulic system on the 300 uses closed center valves with a constant displacement pump. The orfice and the unloader valve work together to control whether the oil goes to the valves or dumps back to the reservoir. When oil is not being sent to the control valves the systems has a standby pressure of about 60PSI so a little load on the pump is normal when you are not using the valves. As the valve spools and housings wear it is not unusal for this pressure to rise. If it gets excessive you drill out the hole in the orfice a couple of thousands of an inch to bring the standby pressure back down. That really is a last resort measure when every else is OK. On a system that is being used 150 degrees is not excessive. You would not want to hold your hand on it very long.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|