Farmall & IHC Tractors Discussion Board |
Cub 154 ignition switch question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 888 on July 11, 2007 at 07:16:43 from (64.132.95.90):
Hey all; I redid some dash wiring on the 154 this weekend (the charging inidcator was bypassed) and when I tried to start, there was no response at all. I have good voltage at the battery, the rain started and I have not been able to go back out and check more. I suspect that the physical ignition switch (with key) is not working to provide voltage downstream to the starting switch, here's why. There was a loose ring terminal connection on one of the switch studs and when I tightened the nut down to secure the connection, the complete electrical (brown) half of the switch spun around inside the silver outer housing. I assume that this is not a good thing and I have broken whatever connections exist between the key and the electrical terminals. Anyone else ever had this happen? thanks
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|