Farmall & IHC Tractors Discussion Board |
Re: Cub 154 ignition (now wiring) switch question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 888 on July 11, 2007 at 17:45:37 from (24.209.109.8):
In Reply to: Re: Cub 154 ignition switch question posted by Janicholson on July 11, 2007 at 11:50:16:
Thanks for the input. I swapped it out tonight and while examining the old switch and the replacement switch, I noticed a difference. The old switch had BAT IGN ACC molded on the 3 lower terminals and ST with an arrow on the central "tower" terminal (like a coil terminal on a distributor). The new switch only had the BAT IGN and ACC marked, no ST. The schematic does not mention an ACC position but the key can go to the left to what would be an ACC position on an older car ignition. I was thinking this may be a "universal" ignition switch with an ACC option. When I got the tractor, the wiring was a mess but I clearly recall there was no wiring to the central tower terminal. Is that central terminal the starter terminal? I wired it that way and still no sign of life. However, when I got the tractor the charging meter was bypassed, I may need to replace that to get current flow to the starter switch, I assume the current must flow through the charging indicator to get to the starter switch? For right now, everything is wired as per the schematic and there is no sign of life. Thanks for any comments or advice. Joe
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|