Farmall & IHC Tractors Discussion Board |
Re: Cub 154 ignition (now wiring) switch question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on July 13, 2007 at 10:01:29 from (199.17.6.122):
In Reply to: Re: Cub 154 ignition (now wiring) switch question posted by 888 on July 11, 2007 at 17:45:37:
Sorry for the delayed response. If it has no ST terminal, it probably does not have a spring loaded start position as the key turns! thus it is either the wrong switch, or the unit had a push button starter switch to make the starter solenoid operate. Battery terminal should be attached to (if it were mine) a 35 amp inline fuse holder and fuse. then to the hot side (battery side) of the soleniod. The Ignition terminal should go to the coil (or ballast resistor if so equipped). The Acc terminal is not used unless you have a radio or other device you need to operate while the ign is off. Leave it empty. Without a starter terminal a starter button (momentary contact weatherproof push button) should be connected to the bat terminal of the key, and the start (S) terminal of the solenoid. If it has an alternator, the indicator light should be wired to the Ign terminal on the key (I think) JimN
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|