Farmall & IHC Tractors Discussion Board |
Re: 424 Hydr, sufficient GPM/Pressure for Small Ba
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JayWalt on November 27, 2006 at 16:19:22 from (24.223.138.48):
In Reply to: 424 Hydr, sufficient GPM/Pressure for Small Backho posted by Spence on November 27, 2006 at 07:24:02:
Hey spence, send me an email to cooldude@ilovejesus.net and I'll send ya a nice PDF file for calculating hydraulic cylinder force and speed. You can use that to calculate what cylinders you need. Also, lets say your main boom is 3 feet and your cylinder is connected 1 foot from the pivot, u can use ratios to calculate the actual effective force at the end of the boom. It's never EXACT, but it will definitely tell you if you are underpowered. Your 9gpm, 2100 psi pump should be sufficient if you get the right cylinders... I calulated my dump cylinders on my loader to have an effect force of 1000lbs at the lip, and have rolled a car over with that same lip. Hydraulics rule!! my speed is also good as well, and I'm very happy with my results. Also if you got any questions, I can try to help you out.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|