Farmall & IHC Tractors Discussion Board |
Re: couple of question about 39 M transmistion
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JayWalt on November 26, 2006 at 16:47:00 from (24.223.138.48):
In Reply to: couple of question about 39 M transmistion posted by Paul G. in Mn on November 26, 2006 at 15:22:16:
I suppose if the gears are readily removeable, you could lightly wire brush them with a benchtype wire wheel. make sure its not a very stiff brush. Make sure you air them off and clean them with carb cleaner or soap and water (thoroughly dry them if u use water, I would use a propane torch bneing careful not to concentrate the heat in one spot too long, or a hairdryer/heat gun). Ideally it would be nice to get them clean, but I dont see why it would be detrimental to anything. The rust on the sides will probably never come off by itself, but the constant immersion in oil, if you plan to use it often, will defintiely keep them from rusting further. As for the teeth, that rust will come off in a matter of a few hours of use.
Replies:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|