|
Farmall & IHC Tractors Discussion Board |
couple of question about 39 M transmistion
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Paul G. in Mn on November 26, 2006 at 15:22:16 from (206.183.177.245):
this weekend I went through the transmition on my 39 M. I took everything out and checked all the bearings and replace all the seals. I removed the seal from the lower shaft that drives the lift all pump and the original had 2 differet seals there. The parts book only shows 1 seal there. Should there be a second seal there?. This transmition sat for a long time and the gears that were out of the oil have some rust on them. Should I be concered about that? any way to clean them or will this come off in time? This was the first one of these I have gone through, wasnt bad if you do it in the right sequence( hated repulling the axles and bull gears again) Just glad its done
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
