Farmall & IHC Tractors Discussion Board |
Re: adding an extra reservoir to Lift-All on Farma
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Loren P on August 18, 2006 at 06:50:50 from (64.65.174.118):
In Reply to: Re: adding an extra reservoir to Lift-All on Farma posted by Andy Martin on August 17, 2006 at 14:37:36:
I think all of the oil on the floor of my shop is because I overfilled the Lift-All above the control shaft (I filled it until it overflowed.) I'll set the extra reservoir at a height where the level of the oil is the same as the fill line on the dipstick, and put a vented cap on the extra tank as well to keep the levels equalized. I found a 4" dia. x 12" piece of steel pipe at work, so I'm going to machine two endcaps and weld them to the pipe, with 1/2" NPT couplers welded into holes drilled in the wall of the pipe (one up for filling/venting, and one down for connection to the Lift-All drain.) I'll then weld some studs to the side to bolt to the frame rail.
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|