Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo Sorry! Our Phone System is Down. Please use our Contact Us Form.

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: adding an extra reservoir to Lift-All on Farma


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by Andy Martin on August 17, 2006 at 14:37:36 from (64.219.39.195):

In Reply to: Re: adding an extra reservoir to Lift-All on Farma posted by Nat 2 on August 17, 2006 at 13:59:01:

Almost.

You have to have a vent somewhere. If you don't vent the Lift-All you will tend to fill it with fluid as the air works out if you are connected to the fill connection. When the level is above the control shaft I think you will get leakage.

If you are connected to teh drain connection the fluid would have no incentive to go into the Lift-All as the trapped air above the Lift-All level will keep it out.

BTW, I ruined a tractor running without a vented cap. I had been using it for some time with a pipe plug for a cap and borrowed a neighbor's cultipacker. 13 ft wide and real heavy. I hitched it up and pulled it to the shop to top off the hydraulic fluid. I over filled it.

Took it to the garden and tested it. When I dropped it there was a loud sound. I pushed in the clutch and everything seemd OK. Re-engaged the clutch and more noise. Looked again and oil everywhere.

Summation of damage:
Pressure in the Lift-All split the front of the case pushing it into the pressure plate. Broke all three ears off the pressure plate. The side load on the flywheel broke the crank in the rear main. It is waiting full disassembly and repair, for ten years or so.


Replies:




Add a Reply

:
:
: :

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity! ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy