Farmall & IHC Tractors Discussion Board |
Re: M Engine
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by wareagle on November 17, 2005 at 15:01:13 from (64.178.237.68):
In Reply to: Re: M Engine posted by captaink on November 17, 2005 at 07:33:50:
The Tractor has stepped or dome pistons. I will probably not work the tractor appreciably as we have other stuff to get dirty but like to make good sounds and show it to friends. Mostly it's a challenge. Can I check for bore taper using ring end gap measurements from the bottom of the stroke to the top of the stroke. I get your point about the effects of taper. I thought I knew a little about engine building but I never considered taper since all my other projects were Automotive and followed engine machining. Is a sleeve change easy enough or is it hard to pull the old ones and push the new ones back in on this engine? If this tractor was originally a distillate engine, was it a super M as I thought or was the Super only for those higher compression engines? Also, are there differences between a distillate carb and a gasoline carb? Another question.. Most of the M tractors I have seen were without fenders including ours and also our 400. Did people just remove these and loose them or was this an option?
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|