Farmall & IHC Tractors Discussion Board |
300U Carb: Runs But Dies on Acceleration
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ron Smith on April 08, 2005 at 16:05:58 from (205.188.117.73):
Can"t seem to get this carb going right. I rebuilt the carb about 2 weeks ago. Found that the float (one side) was split. Sealed that up so it floats fine now. It runs great at idle, better then ever. I can idle it up with the screw, but it will stumble at higher idle. The problem is that on acceleration, it dies out all together. I adjusted the float level some and it does the same thing. Checked the linkage and it is working free and is lined up right. It will idle up some, but, a notch higher and it kills it. So, it won"t run wide open or, under load. Adjusted the main jet to several different positions and it does the same thing. Once, it did shoot a flame out of the carb air intake. Anybody have any ideas? I checked for air leaks and couldn"t find any (sprayed wd-40 on it).
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|