Farmall & IHC Tractors Discussion Board |
plowing with three point again...
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MattPage on February 08, 2005 at 07:30:41 from (65.69.27.28):
Okay, was reading yesterdays posts about plowing with an aftermarket three point on a C with no draft control and it threw a stick in my spokes. I was excited about fixing up my H to use at the deer lease. Don't have any drag implements have all three point. Found a junk H with a three point and thought I could put it on my H and use it at the deer lease to keep from transporting tractors (and to get to play on the H). Ussually plant about twenty acres in scattered plots and mow with a brush hog. I thought the plow/disk/and 5-ft. mower would work O.K. if I just used spacers on the lift cylinder to control the depth... its not all level but its not rocket science work either. I haven't used a tractor without draft control at all so I'm only speculating. What do yall think? matt.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|