Farmall & IHC Tractors Discussion Board |
Re: plowing with three point again...
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CNKS on February 08, 2005 at 11:41:32 from (204.249.178.138):
In Reply to: Re: plowing with three point again... posted by Hugh MacKay on February 08, 2005 at 09:58:58:
My point was to keep the mounting brackets tight. My C which did not have a 3 point when I bought it, has a badly worn place on one of the housings, where apparently something had run loose for years, have no idea what it was as I don't know the history of the tractor. It wasn't broken, just worn, I agree that you really have to screw up to break a casting. I was more concerned that the aftermarket 3-points, Saginaw or not, might not be as surdy, simply due to the way they have to be mounted. I grew up on an irrigated vegetable farm. To irrigate you have to have all the ridges and holes filled in or the water will never get across the field. Depth control in that situation did not depend on high and low places but only soil inconsistencies and wet and dry places. In that case, a slight raising or lowering of the mounted plow will take care of any problems, if there is no draft control. Except for the 8N/9N, draft control hadn't been invented when I was on the farm.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|