|
Farmall & IHC Tractors Discussion Board |
Re: 1949 Farmall M battery ign rotor/condensor par
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jamie ivester on April 13, 2004 at 15:35:20 from (68.190.45.252):
In Reply to: 1949 Farmall M battery ign rotor/condensor part #s posted by jamie ivester on April 12, 2004 at 20:54:07:
The distributor looks like it came on the M (looks like original red paint on it). It has a 90' bend/vertical cap. Everything else on this M is Delco Remy and I'm about 99% sure the distributor is also. I changed the coil to a 12v today and replaced the push/pull switch (it was the culprit) and it fired up today after a few tries but needs new points, condensor, and plug wires. A couple other questions I'll post here in hopes that you guys will see this thread... (1)I assume that the throttle lever all the way back is idle, right?
(2)After it cranked up today, it idled pretty high or at least it seemed to. Could this be caused by the shaft from the gov to carb being turned 180'? when it was installed after reinstalling the carb? When I pushed the lever forward, at some point it idled down...
(3)Whats the shift layout on the M? (it would be nice to know so I don't go through the back of the barn in high gear)
(4)It seemed to only want to crank when it was almost fully choked. I never really let it warm up much and after I cut it off it spit out a lot of gas out the air intake on the carb (had the air cleaner off cleaning it up)
(5)One last thing... I noticed a few random sparks coming from the exhaust manifold while it was running (muffler was off cause its in a barn with low ceiling). Is this normal? The engine sounded strong anyway.
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
