Farmall & IHC Tractors Discussion Board |
49 Farmall M wiring troubles found
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jamie ivester on March 31, 2004 at 17:26:34 from (68.190.45.252):
I have the coil/dist/cutout with battery ignition. This tractor has been in the barn for i don't know how long but my father in law says that it was used last sometime in the past 10 years. Just to see what kind of shape it is in I hooked up a new 6 volt battery today and hit the start switch... nothing after a few times... then I tapped the pedal a little harder and it slowly turned over for me. I turned it over a few times and then it lost it. I disconnected the battery and noticed that lightswitch/ammeter box had the burnt wire smell and the case felt a little warm (it was cold today). Any ideas on what I'm looking at here or what my next steps should be? Repair manual is in the mail by the way along with a 12 volt conversion kit w/harness that I hope will solve the problem anyway. Could the switch be bad? If so, can I just wire the new 12 volt lights up to a separate switch and not use it? Let me know what I'm missing here.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|