|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Farmall 350 vs ihc high utility350
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dr.EVIL on October 18, 2003 at 18:22:53 from (216.170.153.142):
In Reply to: Re: Re: Re: Farmall 350 vs ihc high utility350 posted by Hugh MacKay again on October 18, 2003 at 16:06:13:
Hugh - I don't think ANY of the castings of a utility interchange with a Farmall. No siderails on the utility, and the clutch housing is way shorter on the utility. The bull gear & pinion ratio is different between the utility & Farmall also because of the rear tire size difference... and the ring gear & pinion ratio may be different as well. Other than a few transmission gears, the T/A unit itself, the clutch, and some hardware I bet not much interchanges. And looking at the 300/350 gas engine parts books most of the parts ARE H parts with advanced suffixes on the part numbers which means they are retrofitable backward from 350 to 300 to Super H to H. There were running changes made to things like wrist pins in pistons but the raw connecting rod was still the same forging just machined different. The suffix could have been changed because of a change in heat treatment or something. I will agree with You 100% that not much off a 300/350 Farmall will interchange with an H. Mostly just the simple bolt-on stuff on the engine interchanges but from the flywheel on back Everything is different. Some stuff likes wheels & rims will fit, but the correct parts are different.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
