Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: farmall H questions


[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Nebraska Cowman on September 09, 2003 at 17:45:39 from (65.172.143.89):

In Reply to: farmall H questions posted by Zach on September 09, 2003 at 08:59:45:

1. The H was badly leaking oil from the rear seal. We split the tractor and replaced the seal as well as all of the little gaskets that are in that area. I took the top and bottom pieces that the rear seal lies in to a machine shop and had the surfaces ground. We put everything back together and when the tractor heats up, it still leaks a fair amount although not as bad as it had. What else can I do to stop it from leaking? I don't worry too much about a little leak. Oil is cheap.
2. Fifth gear has a rattle in it and the shift lever seems awful sloppy, especially in reverse. I haven't tore into the transmission yet but can anyone give me any hints / suggestions as to what may need replaced / repaired? A lot of the shifters get loose where the pin holds the lever in the case. there is a round bushing that the pin goes through. sometimes you can replace the pin and or the bushing. if the hole in the case is worn you can drill it out and use a larger pin.
3. The ammeter is showing a slight discharge when the tractor is running. It is still the original positive ground six volt system and I just replaced the battery. What should I check? Is it distributer or magneto? Does the battery run down? the ammeter could be wired in backwards.


Follow Ups:




Post A Followup

:
:

: Re: Re: farmall H questions

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle? ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy