Farmall & IHC Tractors Discussion Board |
Re: Farmall 100 change from 6 to 12 volt?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on July 10, 2003 at 11:04:02 from (64.228.11.173):
In Reply to: Farmall 100 change from 6 to 12 volt? posted by mdshilli on July 10, 2003 at 08:59:00:
Mike: Mush more simple than that. You go from Pos to Neg ground. Mount your alternator, I like to use a double pulley from the last V8 Olds or Buick, allows you to place alternator back farther, thus lower, and use the outer pulley. I always change coil from 6 to 12 volt, saves fooling with those resistors. Starter and distributor need not be touched. I use the two wire system and the extra wire in your harness can be used for an excite wire. I put a starter type push button on dash for exciting alternator. With the push button this avoids the risk of it being left on and thus running battery down when tractor is not in use. Only other item is your lights. Any questions on details just ask.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|